9150-065-M-5-18
1
SECTION 1 - INSTALLATION 8
8
8
9
10-13
13
14
15
16
17
1.1 Hardware for the Gate
1.2 Physical Stops for the Gate
1.3 Types of Gates
1.4 Operator Mounting Positions
1.5 Underground Conduit Requirements
1.6 Pad, Post or Ceiling Mount without / with J-Box Setup
1.7 Mounting Operator and Chain
1.8 Installation of Warning Signs
1.9 Chain Tray Kit
SECTION 2 - AC POWER TO OPERATOR(S) 18
18
19
2.1 High Voltage Wire Runs
2.2 High Voltage Terminal Connection
SECTION 5 - WIRING 29
29
30
31
32
5.1 Main Terminal Description
5.2 Control Wiring for Single/Primary Operator
5.3 Auxiliary Device Wiring
5.4 Bi-Parting Gates Wiring - Dual Gate Operators
SECTION 7 - MAINTENANCE AND TROUBLESHOOTING 37
7.1 Maintenance
7.2 Troubleshooting
7.3 Accessory Items
Model 9150 Wiring Diagrams
37
38-39
40
41-42
SECTION 6 - OPERATING INSTRUCTIONS 33
6.1 AC Power and Reset Switch
6.2 Shutdown Conditions
6.3 Manual Gate Operation
33
34-35
35-36
SECTION 8 - OWNER OF GATE OPERATOR 43
8.1 Alarm Sounding and Gate WILL NOT Operate
8.2 Manual Gate Operation
8.3 Gate Operators Monthly Checkup
Printable Safety Page
43
44
45
46
SECTION 3 - ADJUSTMENTS 20
3.1 4602 Circuit Board Description and Adjustments
3.2 DIP-Switch SW 1 and SW 2 Settings
3.3 Automatic Open / Close Limit Adjustment
3.4 Clutch Adjustment
3.5 Inherent Reverse Sensor Adjustment
20
21-22
23
24
24
SECTION 4 - ENTRAPMENT AND SAFETY PROTECTION 25
4.1 UL 325 Terminal Description
4.2 Entrapment Protection Device Locations
4.3 Loop Detector Wiring
25
26-27
28
TABLE OF CONTENTS
Quick Guide: DIP-Switches
Quick Guide: Terminal Descriptions
Operator Specifications
Slide Gate Requirements
Safety Information for Slide Gate Operators
ASTM 2200 Standard for Gate Construction
Important Safety Instructions
Instructions regarding intended installation:
Important Notices
UL325 Entrapment Protection
Glossary
Quick Guide-1
Quick Guide-2
Previous Page
2
3
4
4
4
5
6
7
QUICK GUIDES
To Next Page
Loading...
