•
With a valve stem seal fitting jig,
assemble the valve stem seal with the
valve guide.
•
After installing valve springs and spring
retainer, press the retainer with a jig, then
install cotter pin.
•
Tap the valve stem lightly with a rubber
hammer to check that the valve is
assembled correctly.
9.3.27. Cylinder head
•
Blow the bolt holes of cylinder block with a compressed air and remove the foreign matter.
•
Clean the head gasket contact surface thoroughly.
Caution :
However, be careful for the foreign mat-erial not to enter into the combustion chamber.
•
Assemble the new head gasket by align-
ing the holes with dowels of cylinder
block with ‘TOP’ mark facing upward.
- 113 -
To Next Page
Loading...
