Doosan DE08TS - Cylinder Liner; Camshaft Gear and Idle Gear

DE08TS Diesel Engines Maintenance
<Disassembly of piston>
1. Remove the snap rings by means of a plier.
2. Heat the piston with a electric heater, then take
out the piston pin from the piston as tapping it with
a round wooden bar.
3. Remove the piston ring with a plier.
4. Clean the piston thoroughly.
Cylinder liner
1. Diassemble the cylinder liner with a special tool or
hand but be careful not to generate any damage
at cylinder block.
Cam shaft gear and idle gear
1. Unscrew the camshaft gear fixing bolts and
remove the camshaft gear.
2. Unscrew the camshaft gear fixing bolts and
remove the camshaft gear.
EAMD087I
EAMD088I
34