14
Go to Table
of Contents
do moves in normal mode.
When the shaft learning end, you make moves from floor to
floor to see if the lift reaches the floor level accurately.
If it does not then we check first the pencil magnets to be very
close to the magnets. If the problem still existing, then we
change the parameters in menu P4/K7.
MKU STOP/MKD STOP changing them apart. First MKU check-
ing from floor to floor and then MKD.
After that, the lift is ready to use in normal operation.
Troubleshooting (Continue)
To Next Page
Loading...