27
Go to Table
of Contents
65 Brake Not Opened
Although brake coil is energized, signal is received from
brake feedback contact. Check BR1, BR2 terminals, con-
tacts, definitions and related wiring. This error is report-
ed only if the parameter A16 was set to 1 [A16=1].
Cause
Troubleshooting
1. M7-U1 enter to reset the UCM related fault.
2. This error appears when the brakes are active but the feedback
is not turning the led o.
This is usually a fault of the microswitches position and seems
they need adjustment.
TIP: Check electrical drawings pages 2-3
To Next Page
Loading...