Doppler DLC - 39 Group No Failure

To Next Page

To Previous Page

Go to Table

of Contents

39 Group No Failure

There is more than one member in the group with the

same group number speciﬁed in [A13]. Check [A13] pa-

rameters of all lifts in the group.

Cause

Troubleshooting

1. Check if the edit number of the group is increasing from board

to board in the group connections.

2. Check if the Can-Bus connections are going from CH2-CL2

from board to board with direct connections.

And if the CAN2 is programmed at GROUP CAN CHANNEL

A20 parameter, equal to 2.