Use the USB C to USB A cable provided with the scale to connect to the PC. If
customer supplied cables and or converters are used be sure these support data
transmission.
Once plugged into the PC, the scale will charge from the PC USB power supply
so the scale will display the corresponding charging light when connected to the
PC.
This device requires Windows 10 or higher. The USB driver may need to be
installed to support this module. Open Device Manager and expand Ports (COM
& LPT) then plug the USB A connector into the PC. If the driver has been
installed, USB-SERIAL CH341A (COMX) will appear once plugged in.
If you do not see the device in the Ports (COM & LPT) after connecting to the
PC, you will need to install it. Download the driver it from
www.doranscales.com/USB. Run the downloaded CH341SER.exe to launch the
installer. Open Device Manager and expand Ports (COM & LPT) then plug the
USB A connector into the PC. If the driver has been successfully installed, USB-
SERIAL CH341A (COMX) will appear once the USB cable is plugged in.
If you are not sure that the driver was installed properly, search the C drive for
oem129.inf. If installed, this file will be present in the C:\Windows\INF directory.
To Next Page
Loading...
