4.5.2.9 Wireless
Further information about wireless can be found in the PG wireless manual.
This menu offers the following options:
• Connect the component to the network
• Disconnect the component from the network
• Display the status of the component in a network
Procedure for connecting a component to a wireless network
Requirements
• Component with E320, 321, 340, 341, 360, 361
• Configured wireless gateway
• Master medium of the site
Configuring the wireless menu
1. Open the 'Settings' menu.
2. Open the 'Actuator' menu.
3. Log the master medium in to the actuator.
4. Connect the programmer to the actuator.
5. Select the 'Wireless' sub-menu.
6. Press the ENTER key.
The following options are available in the 'Wireless' menu:
• Connect to the network
• Disconnect from the network
• Display status of the network
Procedure for connecting to the network
1. Choose Connect.
2. Confirm with ENTER.
ð Search for network... (Network is searched for.)
ð Gateway (GW) found.
ð Connecting to the GW is executed.
ð Putting into operation...
ð Connected to GW.
ð The linked actuator is connected to the network.
Procedure for disconnecting the network connection
1. Choose Disconnect.
2. Confirm with ENTER.
ð The network is exited.
Procedure for displaying the network status
1. Choose Status.
2. Confirm with ENTER.
ð The component status is displayed.
The programmer display contains the following:
SW Software version, e.g. 00.0024
NW Network, e.g. standalone or wireless
Operation User Manual
24 - 06/2021dormakaba Programmer 1460
To Next Page
Loading...