Dormakaba 1460 - 6 System Connection; 6.1 Driver Installation Procedure

To Next Page

To Previous Page

6 System connection

This section describes data transfer between the system software and the programmer.

6.1 Driver installation

Administrator rights are required for installation.

This section describes the installation of drivers.

Direct link to protected area: https://cms.dxp.dormakaba.net/blueprint/servlet/extranet-

emea-de/support/electronic-acces-data/software-downloads/evolo-programmier-

tool-582698

Content of installation package:

• Programmer 1460 USB driver

• dormakaba EAC Service Tool

• documentation

Requirements

Hardware requirements:

• Windows PC

• Processor with 1.4GHz or higher (2.4GHz recommended)

• Main memory 1 GB (2 GB recommended)

• Hard drive memory min. 50 MB, including all additional components

• Interface: 1 x USB 2.0

Supported operating systems:

• Windows 10 (32/64 bit)

• Windows 8 or 8.1

• Windows 7

• Windows Server 2012

• Windows Server 2008

• Windows Server 2008 R2

Procedure

1. Download the installation package from the dormakaba website.

2. Unpack the installation package.

3. Open the installation package.

ð Programmer file path: ..\evolo-toolchain\Programmer 1460\Driver

ð EAC Service Tool file path: ..\evolo-toolchain\EAC Service Tool

4. Programmer: Select and launch the Install file.

EAC Service Tool: Select and launch the EvoloServiceToolSetup file.

5. Follow the instructions of the installation programme.

6. After being prompted, connect the programmer to the PC using the USB cable.

System connection User Manual

40 - 06/2021dormakaba Programmer 1460