06-2023 dormakaba Canada Inc. RAC5 MFC Installation Guide – PK3738 | 3
1 Introduction and Disclaimers
Please read and follow all directions carefully.
These instructions are designed for use by qualified installers or individuals with knowledge of common safety
practices and the competence to perform the steps described herein.
dormakaba Canada Inc. is not responsible for damage or malfunction due to incorrect
installation. The dormakaba RAC5 MFC is intended for guest pass level elevator floor
control only and is not designed to provide any Emergency/Fire Recall operations or
control. Emergency/Fire Recall operations and control are managed by separate elevator
control systems and outside of the dormakaba RAC5 MFC system.
Carefully inspect windows, doorframes, doors, etc. to ensure that the installation
not cover damages caused by installation.
Installation of card readers or other peripherals within elevators must only be done with
prior consultation of the elevator manufacturer. A technician from the elevator
manufacturer should always be present for installation. Do not connect to a receptacle
controlled by a switch.
If installing the RAC5 MFC in an elevator cage environment, or in proximity to any other equipment that may
generate high levels of electromagnetic interference, follow the installation requirements as indicated in
Annex C to prevent any operational instability.
The Table below outlines Access Control Levels as they pertain to certain Features.
To Next Page
Loading...
Need help?
General