30 Saflok RT/RT Plus Installation Guide PK3720_T 04-19
B.5 Install Outside Housing and Trim Assembly for
Cylindrical
1. Insert the slotted end of the square spindle (G) into the
outside lever hub until it locks, at an angle of 45º. (The
spindle can be removed by pulling on it, if oriented incor-
rectly.)
Square Spindle Position
correct incorrect
2. Insert the thumbturn spindle (F) in the upper hub of the
outside housing. (It will clip in place.)
3. Assemble the gasket onto the outside housing. Assemble
the cylindrical plate assembly onto the outside housing.
B1 - Lock Housing
N - Gasket
X
Y- Cylindrical
Plate Assembly
F
G
4. Place the outside housing on the door so that spindle (F)
engages the thumbturn hole and spindle (G).
For models 79Z, 79Y, 79Q connect the cable (X) to the cable
(W - not shown).
For model 79R leave the cable (X) in the door.
Make sure both cables are not pinched between the inside
trim and outside lock on the face of the door. Engage hub of
cylindrical unit. The cylindrical unit will engage the latch as
shown in step 2 of B.3 (page 29).
APPENDIX B Installing Cylindrical Models 2⁄" &
2⁄" Backset
To Next Page