Dors 800 - Daily Maintenance Tasks

39
38
Table 3
Remove
notes from
the stacker
The number of notes in the
stacker is equal to the stacker
capacity.
Remove the banknotes from
the stacker. The machine
resumes counting
automatically (in the automatic
start mode) or after key I (II) is
pressed (in the manual start
mode).
Messages
Remove
notes from
reject pocket
The number of notes in the
reject pocket is equal to its
capacity.
Remove the banknotes from
the reject pocket.
Add
banknotes
The hopper is empty while the
number of notes in the stacker
is less than the required batch
size (in the AUTOMATIC
START mode).
Add banknotes to the hopper,
the machine resumes
counting automatically.
Add
banknotes
and
press start
The hopper is empty while the
number of notes in the stacker
is less than the required batch
size (in the MANUAL START
mode).
Add banknotes to the hopper,
press key I (II).
Clean
the pockets
Counting settings/modes were
changed after a count is
finished.
Remove the banknotes from
the stacker and the reject
pocket.
Batch
is ready
A batch of required size is
counted.
Remove the banknotes from
the stacker and resume
counting.
Function
is unavailable
You tried to choose the
function unavailable for the
current counting mode (for
example, tried to choose a
currency in the COUNT mode
or a batch size in the MIX
mode).
Switch to the correct counting
mode and then choose the
required function.
Self-testing.
Please,
wait till
operation
completion
The self testing is in progress. Wait till the message box is
disappeared.
DORS 800 BANKNOTE SORTERDORS 800 BANKNOTE SORTER
Table 3
Calibration.
Please, wait
till operation
completion
The sensors are in course of
calibration (the calibration is
ran automatically at the
moment of switching on and
then every 30 minutes).
It is impossible to take
banknotes out of the hopper.
Wait till the message box is
disappeared.
Adjust the hopper's guides
according to the length of the
longest note in the batch.
Adjust the feeder gap if
required («+» means gap
increase) for operation with
thicker banknotes. To get the
required gap, turn screw 1
(Figure 1) counterclockwise.
There are no
banknotes.
Feed error
The machine is going to be
reset to the factory setting.
Confirm or cancel the reset to
the factory setting.
Reset
confirmation
Messages
MAINTENANCE
According to experience of the world vendors, we suggest to call the
technician for the professional maintenance every 90 days. If you use the
machine more than one shift a day and the most of counted banknotes are dirty
and soiled, more frequent maintenance is required.
On a daily basis:
1 Switch off the banknote sorter if you do not use it.
2 Wipe the sorter external parts with a dry clean lint-free tissue.
3 After work is completed and the sorter switched off, clean the sensors
from dust and fine particles with a soft lint-free tissue or a soft bristle
brush. The sensors 1-8 shown on Figure 4, Figure 5, Figure 6,
Figure 7 shall be cleaned. In case of strong soiling, it is allowed to wipe
the sensor with the lint-free tissue wetted with isopropyl alcohol.
Attention! Before cleaning the sensors, make sure that sorter is switched
off and the power cord disconnected from the power supply!
Reason Teller's actions
Reason Teller's actions
Batch of XXX
notes is ready
where YYY is
in stacker and
ZZZ are removed
The message is appeared
when you count a batch where
selected number of notes is
more than a current limit of the
stacker.
Remove banknotes from the
stacker and continue a count.