12
Push [ENTER/MENUE] and use the up and down keys
[
] to select ArEA. Push [ENTER/MENUE] to con-
firm. On the left corner of the display appears a small
1, which indicates the selected channel. For changing
the channel use the up and down keys [
] . Push
[ENTER/MENUE] to confirm. Use the up and down keys
[
] to select the dimension unit:
c = Centimeter
2
m = Meter
2
Push [ENTER/MENUE] to confirm.
On the display bottom appears:
00.00
For changing the number use the up key [
] . For step-
ping to the next number use the key down [
]. If the
requested dimension is complete then push
[ENTER/MENUE] to confirm.
1.4.7 Memory Setup [Lo6]
Only instrument with extension –LOG (e.g. P755-LOG)
have got an internal memory.
Push [ENTER/MENUE] and use the up and down keys
[
] to select Lo6. Push [ENTER/MENUE] to confirm.
Use the up and down keys [
] again to start [on] or
Stop [off] the logger. Push [ENTER/ MENUE] to confirm.
Use the up and down keys [
] again to select
between automatic storage [Auto] or manually operat-
ed storage [SPot]. Push [ENTER/MENUE] to confirm].
Use the up and down keys [
] again to select
between to add on data [Add] and creating a new file
[nLo6]. Push [ENTER/ MENUE] to confirm. By selected
automatic storage at the end you have to select the
time interval:
1 S 1 second
5 S 5 seconds
10 S 10 seconds
20 S 20 seconds
30 S 30 seconds
1 M 1 minute
2 M 2 minutes
5 M 5 minutes
10 M 10 minutes
20 M 20 minutes
By selected manually operated storage you are able to
save the measurement by pressing ESC by each time.
Push [ENTER/MENUE] to confirm. Push [ESC] to be back
in the measuring mode. Manual storing [Spot]. Press the
key [ESC] to store manually the measuring values.
Unit
MENUE
Prob Lin2 CAL PrEn Chnl ArEA Lo6