3
Operation Manual
Summary
1. Handling
1.1. General advices
1.2. Setting to work
1.3. Switch on/off
1.4. Menu
1.4.1. Measuring unit switching (UNIT)
1.4.2. Probe selection (Prob)
1.4.3. Difference temperature (Lin2)
1.4.4. Calibration (CAL)
1.4.4.1. Calibration
combination probe
(temperature/humidity)
1.4.5. Channel activation (Chnl)
1.4.6. Enter Area for volume flow (ArEA)
1.4.7. Memory setup (Lo6)
1.5. Recalling memory data
(HOLD/MAX/MIN/AVG)
1.6. Measuring rate (FAST-modus)
1.7. AUTO-OFF-function
1.8. Special-functions
1.8.1 Ohm/microvolt/volt/hertz display
1.8.2 Zero adjustment
1.8.3 Deactivation of the 2nd channel (toggle)
2. Power supply / Changing the battery
3. Error codes / troubleshooting
4. Technical data
5. Interface protocol
6. Connector layout
7. Data of probe-calibration
8. Guarantee
To Next Page
Loading...
