6
To change the measuring unit push [ENTER/MENUE].
Use the up and down keys [
] to select Unit. Push
again [ENTER/MENUE]. On the left corner of the dis-
play appears a small 1, which indicates the selected
channel. For changing the channel use the up and
down keys [
] Push [ENTER/MENUE] to confirm.
On the right corner of the display appears °C or °F, or
%rH, td or gm
3
(depending on the selected probe).
Use the up and down keys [
] again to adjust the
requested measuring unit and push [ENTER/MENUE] to
confirm. Push [ESC] to be back in the measuring mode.
1.4.2 Probe selection / [Prob]
Push [ENTER/MENUE] to change a probe. Use the up
and down keys [
] to select Prob. Push [ENTER/
MENUE] to confirm.
On the left corner of the display appears a small 1,
which indicates the selected channel. For changing the
channel use the up and down keys [
]. Push again
[ENTER/MENUE] to confirm. On the right corner of the
display appears the active probe. Use the up and down
keys [
] to change the probe. P
ush [ENTER/MENUE]
to confirm the requested probe.
Push [ESC] to be back
in the measuring mode.
Measurement Probe selection LC-Display Suitable for
(Prob) these types
of measuring
instruments:
Temperature Pt100 (RTD) P700/P705/
P750/P755/P770
P755-LOG/P770-LOG
Temperature Fe-CuNi Type J for all P700-
instruments
Temperature NiCr-Ni Type K for all P700-
instruments
Temperature Fe-CuNi Type L for all P700-
instruments
Temperature NiCrSi-NiSi Type N for all P700-
instruments
Temperature Pt13Rh-Pt Type R P700/P705/
P750/P755/P770
P755-LOG/P770-LOG
Temperature Pt10Rh-Pt Type S P700/P705/
P750/P755/P770
P755-LOG/P770-LOG
Unit
MENUE
Prob Lin2 CAL PrEn Chnl ArEA Lo6
Unit
MENUE
Prob Lin2 CAL PrEn Chnl ArEA Lo6