13
1.5 Recalling the memory data
(HOLD MAX MIN AVE)
After pushing first time the key [HOLD MAX MIN AVE]
the actual value will be hold on the top display line (big
display). Pushing again the key [HOLD MAX MIN AVE],
the saved maximum-, minimum and average value will
be displayed in the bottom display line (small display).
Note for 2-channel instruments: First the MAX-MIN-
AVE-values of channel 1 will be displayed – afterwards
the values of the channel 2 will be displayed. Is there
only one probe on a 2-channel instrument we suggest
to deactivate the channel without probe (menu Chnl).
Note:
During the recall of the memory data the extremes
(MAX MIN) and the average value (AVE) will not be
calculated or carried on.
Clearing the memory (MAX MIN AVE)
Press [CLEAR] key once to erase the stored maximum,
minimum and average from memory. On the display
appears Clr. – After erasing the memory the instru-
ment automatically switches back to measuring mode
indicating the actual measured value again.
1.6 Measuring rate (FAST-mode)
Press [FAST/
]key once to change the measuring rate.
Now the measuring rate is app. 4 measurements per
second. Press [FAST/
] key again and the instrument
is back in the standard mode (1 measurement per sec.).
Note:
In the fast mode the battery consumption is three
times higher than in the standard mode.
1.7 AUTO-OFF-function
dAoF = Disable Auto-off
EAoF = Enable Auto-off
Press [ESC/AUTO-OFF] key once. On the display
appears EAoF. Now the instrument switches off auto-
matically after app. 30 minutes. Press [ESC/AUTO-OFF]
key again. On the display appears dAoF. Now the
Auto-Off-function is deactivated.
1.8 Special-functions
1.8.1 (Ohm//Micro volt/Volt/Hertz-display)
If you want to get the shown value displayed according
to the basic units you will have to push, when you
switch on, the keys FAST and ON/OFF at the same time
for approximately 3 seconds till the next basic unit
appears:
Important!
Important!
To Next Page
Loading...
Need help?
General
