To Next Page

To Previous Page

30 DR

POWERWAGON-PRO

Figure 29

Removing and Replacing the Stake Body or Molded Body

WHEN PERFORMING ANY MAINTENANCE, YOU MUST FIRST SHUT OFF THE ENGINE, SET THE

PARKING BRAKE, WAIT FIVE (5) MINUTES TO ALLOW PARTS TO COOL AND DISCONNECT THE SPARK

PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.

Tools Needed:

• (2) 1/2" Open-End or Box Wrenches

1. Position the machine on a level surface and set the Parking Brake.

2. Tip the Bed forward.

3. Remove the four (4) sets of Nuts and Bolts securing the Body

(Figure 29).

NOTE: The 4th set of

Nuts

Bolts is

dde

Nuts

Bolts to remove.

Questions and Answers:

Need help?

Do you have a question about the DR POWERWAGON-PRO and is the answer not in the manual?

DR POWERWAGON-PRO Specifications

General