What to do if Dräger Alcotest 9510 shows ADJUST ERROR?
If you observe an ADJUST ERROR during calibration procedures on your Dräger Test Equipment, it indicates that an IR or EC sensor calibration factor required a significant change. A technician can manually adjust alcohol calibration factors closer to the target and then repeat the QAP Calibration.
What to do if Dräger Alcotest 9510 Test Equipment shows CAL GAS SUPPLY error?
If your Dräger Test Equipment displays a CAL GAS SUPPLY error, it means the minimum flow is not being observed from the dry gas cylinder or simulator. Check if the cylinder is empty or if the tubing from the dry gas regulator is properly connected. If using a simulator, verify the tubing connections between the simulator and the instrument.
Why does Dräger Test Equipment show alcohol in the environment?
If your Dräger Test Equipment shows alcohol in the environment, it means that contamination of ambient air was detected. To resolve this, make sure the surrounding air is clean and free of alcohol. Ventilate the test room to ensure a clear environment.
What to do if Dräger Test Equipment displays 'Mouth Alcohol'?
If your Dräger Test Equipment displays 'Mouth Alcohol', it indicates there's residual alcohol in the mouth of the person being tested. You should remedy the cause by waiting, and then repeat the measurement after the waiting time, observing the control time.
What to do if Dräger Test Equipment has no function after power-on?
If your Dräger Test Equipment shows no function after being powered on, the issue might stem from defective fuses or an insufficient power supply. You should check the fuses and replace them if necessary. Also, verify the power supply to ensure it is adequate.
What does 'Interference' mean on Dräger Test Equipment?
If your Dräger Test Equipment displays 'Interference', it means that the two independent measuring systems have detected an impermissible influence on the measuring values by foreign substances in the breath. Identify the cause of the influence and remedy it if possible. If required, initiate other evidential measures.
How to fix 'Zero Test Incorrect' on Dräger Test Equipment?
If your Dräger Test Equipment shows 'Zero Test Incorrect', it means that the zero adjustment is incorrect. Ensure that the ambient air is clean and free of alcohol. Air the test room to provide a suitable environment for testing.
What does 'Check Airway' mean on Dräger Test Equipment?
If your Dräger Test Equipment displays 'Check Airway', it indicates that the necessary volume for purging the measuring system has not been reached. Check the breathing hose inlet. If no abnormalities are found, restart the measurement. If the fault occurs again, inform Dräger Safety.
What to do if Dräger Test Equipment says 'Minimum Volume Not Achieved'?
General| Brand | Dräger |
|---|---|
| Model | Alcotest 9510 |
| Category | Test Equipment |
| Language | English |
To Next Page
