What to do if Dräger Respiratory Product radio cannot be coupled to communication unit?
If the Dräger Respiratory Product radio cannot be coupled to the communication unit, make sure you are using a suitable insert. Also, check the Bluetooth settings on the radio and couple the communication unit to the radio again.
How to fix Dräger Respiratory Product battery compartment that cannot be closed or opened?
If the battery compartment of your Dräger Respiratory Product cannot be closed or opened, ensure the screw is completely loosened, lifting it if necessary. Also, check for any blockage of the cover, inspecting the sealing and greasing or replacing it as necessary. Finally, clear the path and carefully open or close the cover.
What to do if there is no output to Dräger Respiratory Product earphone?
If there is no output to the earphone of your Dräger Respiratory Product, it could be due to an incorrect configuration. Check the configuration with PC software and change it if needed. It could also be that the earphone is faulty, in which case you should replace it.
What to do if Dräger Respiratory Product earphone is too quiet?
If the earphone of your Dräger Respiratory Product is too quiet, first check the volume and adjust it if necessary. Also, ensure the earphone is correctly positioned. If the issue persists, the battery voltage may be too low, so replace the batteries.
How to fix unclear voice amplifier unit on Dräger FPS-COM 7000 Respiratory Product?
If the voice amplifier unit's sound is unclear, the loudspeaker or membrane might be soiled; clean the communication unit. Another possibility is water in the loudspeaker; allow the communication unit to dry.
What to do if I have no connection to members of my own group on Dräger FPS-COM 7000 Respiratory Product?
If you have no connection to members of your own group on your Dräger Respiratory Product, the incorrect group may be set. Select another group.
What to do if the pressure switch jams on Dräger FPS-COM 7000 Respiratory Product?
If the pressure switch on your Dräger Respiratory Product is jamming, it is likely that the pressure switch is soiled. Clean the pressure switch.
What to do if there is no output to earphone on Dräger FPS-COM 7000?
If you are not getting any output to the earphone of your Dräger Respiratory Product, it could be due to an incorrect configuration, such as the earphone being fitted on the left but the communication unit configured for output to the right earphone; check the configuration with PC software and change it. Alternatively, the earphone itself might be faulty; replace the earphone.
How to fix communication unit that will not switch on for Dräger FPS-COM 7000?
If you cannot switch on the communication unit of your Dräger Respiratory Product, it could be due to several reasons. The batteries might be depleted, so replace them. The batteries might not be inserted correctly; insert them according to the markings. The ON/OFF button might be soiled; clean the ON/OFF button. You might have temporarily selected HazMat mode; restart the communication unit without HazMat mode.
Why can I hear members of other groups on my Dräger Respiratory Product?
If you are hearing members of other groups in addition to your own group on your Dräger Respiratory Product, it is likely that the group is used more than once. Check the resource planning and use of groups. Alternatively, select another group.
Provides essential information for the proper use of the communication unit.
Defines warning signs used in the document for user attention and safety.
Provides a visual guide to the communication unit's components and their numbering.
Details the technical specifications, functions, and operational capabilities of the communication unit.
Explains the functional principles of team radio and tactical radio communication.
Covers the product's intended use, limitations, and provides information on product approvals.
Lists the different types of inserts available for the communication unit.
Covers unit behavior, status display, accessory connection, and power operations.
Details the procedure for turning the communication unit on and off.
Details switching to HazMat mode and adjusting the volume controller.
Explains how to select groups and configure the communication unit via PC software.
Covers preparations for first use and fitting the correct insert.
Guides on attaching the unit to the facepiece and pairing it with a radio via Bluetooth.
Outlines the steps to ensure the unit and radio are ready for operation before starting a shift.
Provides cautions and notices for using the unit during operation, including Bluetooth connection interruptions.
Lists common faults like unit not switching on or no voice amplification, with their causes and remedies.
Addresses problems with voice amplification clarity, earphone volume, and output.
Covers Bluetooth pairing issues and mechanical problems with the battery compartment.
Details troubleshooting for fitting/removing the unit, cable connections, and push-button/switch issues.
Specifies the recommended maintenance intervals for checking the unit's functionality.
Provides detailed steps for cleaning the communication unit and its components, including drying.
Introduces maintenance tasks and highlights precautions for assembly work.
Details procedures for replacing batteries and earphones, including safety warnings.
Guides on replacing fastening eyes and dismantling the communication unit from the facepiece.
Covers installing firmware updates and methods for transporting the communication unit.
Provides guidelines for storing, disposing of the unit, and lists technical data.
Lists designations and corresponding order numbers for the communication unit and its accessories.
Outlines the warranty terms, conditions for claims, and the importance of following instructions for use.
General| Operating Time | Up to 10 hours |
|---|---|
| Water Resistance | IP67 |
| Frequency Range | 400 - 470 MHz |
| Bluetooth | Yes |
| Hands-free Function | Yes |
| Approval | EN 137 |
| Ambient Temperature | -30 °C to +60 °C |
| Loudspeaker Volume | Up to 95 dB |
| Product Type | Communication Device |
| Communication System | Digital radio communication |
| Compliance Standards | EN 137 |
| Operating Temperature Range | -30 °C to +60 °C |
To Next Page