4
5. Determine the current setting for measurements that are out of range.
Select CONFIG > UNIT. One of the screens below will appear. The
default for devices with SW 1.20 or higher is HI: >20 or HI: >340,
depending on the unit configured. For devices with SW 1.10 or lower,
the default is not editable and will only be a blinking zero.
NOTE: To change this setting to blinking zero (HI: -0-), refer to the
instructions for use. It must be changed using the data transmission
software, SW JM-S1w. Requires JM-S1w version 1.40 or higher.
To Next Page
Loading...
