Draminski DOD2 - Pre-Examination Preparation; Examination Procedure Steps

22 SECTION 6 | ANIMAL EXAMINATION
Follow the steps below prior to the examination:
a) turn the device on and check the display to see if the
battery charge level is sucient,
b) prepare a disinfectant to sterilize the probe (see sec
-
tion: DISINFECTION),
c) if the vulva area is dirty, wash and wipe it,
d) in order to use the possibility of saving the results to the
memory, activate the advanced operating mode in the
menu of the device, make sure that the date and time
are set correctly, select from the list an animal to be ex
-
amined (or add a new animal in the menu, see section:
MAIN MENU).
Examination:
a) to facilitate the measurement, you can place the bitch
on a platform,
b) turn on the device,
c) gently stretch the animal’s vulva and start gently insert
-
ing the probe of the instrument into the animal’s vagina
(see section: PROBE INSERTION METHOD),
d) the measurement should be taken at the lower or upper
edge of the cervix os, the upper edge being less pal
-
pable,
e) then carefully perform a circular motion in the axis of
the device in order to get the best possible contact be
-
tween the electrodes and the mucus.
If the device is in the measurement mode, a ashing “1”
digit appears on the display, which means that the de
-
vice is waiting for the rst measurement,
DOD
LASSIE
01.01.2019
11:50
1 2 3
MenuStartList
DOD
LASSIE
01.01.2019
11:50
1 2 3
MenuStartList