Do you have a question about the Draminski DOD2 and is the answer not in the manual?
Category | Diagnostic Equipment |
---|---|
Display | LCD |
Measurement Principle | Ultrasound |
Animal | Sheep, Goats |
Operating Temperature | 0°C |
The main Dramiński DOD2 electronic ovulation detector unit.
The complete user manual for the Dramiński DOD2 device.
The probe features two measuring electrodes for electrical resistance measurement.
The device's screen, displaying information with LED backlighting.
Key functions for power control, menu access, and cancellation.
Key used for confirming selections and initiating measurements.
Screen indicating model, battery status, and measurement progress.
How to configure the number of measurements per cycle.
Importance of clean electrodes and avoiding lubricants.
Pre-examination procedures including device check, disinfection, and animal prep.
Steps for placing the bitch, inserting the probe, and performing measurements.
Procedure for initiating a measurement and the corresponding display message.
Technique for improving electrode contact with vaginal mucus.
Guidance on gently stretching the vulva and inserting the probe to the correct depth.
Advice on the correct angle for probe insertion, varying by breed and size.
Method for rotating the probe for optimal contact with vaginal mucus.
Emphasizing consistent probe depth and location for reliable results.
Requirement to disinfect the detector before and after each test for proper use.
Using manufacturer-specified concentrations to avoid irritation or damage.
Emphasizing cleanliness to prevent reproductive tract infections.
Explaining graphs of vaginal mucus resistance and optimal mating times.
Guidance on interpreting readings between 100-200 and above 200 units.
Pinpointing mating time based on maximum resistance and subsequent decline.
Selection between simplified and full-featured device operation modes.
Display message when the device's batteries are discharged.
Step-by-step guide for replacing the device's batteries.