Vigor130 Series User’s Guide
31
the Host PC) to access into Internet. However, if this box is
checked in PPPoA protocol, only PPPoE clients on the LAN
will be served and only one session is allowed.
WAN Connection
Detection
Such function allows you to verify whether network
connection is alive or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference. TTL
value is set by telnet command.
MTU
It means Max Transmit Unit for packet. The default setting
will be 1500.
ISP Access Setup
Enter your allocated username, password and authentication
parameters according to the information provided by your ISP.
If you want to connect to Internet all the time, you can check
Always On.
ISP Name – Type the name of the ISP if required.
Username – Type in the username provided by ISP in this
field.
Password – Type in the password provided by ISP in this
field.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
Always On - If you want to connect to Internet all the time,
check the Always On box.
Idle Timeout – Set the timeout for breaking down the Internet
after passing through the time without any action. This setting
is active only when the Active on demand option for Active
Mode is selected in WAN>> General Setup page.
IP Address From ISP
Usually ISP dynamically assigns IP address to you each time
you connect to it and request. In some case, your ISP provides
service to always assign you the same IP address whenever
you request. In this case, you can fill in this IP address in the
Fixed IP field. Please contact your ISP before you want to use
this function.
WAN IP Alias - If you have multiple public IP addresses and
would like to utilize them on the WAN interface, please use
WAN IP Alias. You can set up to 8 public IP addresses other
than the current one you are using. Notice that this setting is
available for WAN1 only. Type the additional WAN IP
address and check the Enable box. Then click OK to exit the
dialog.
To Next Page
Loading...
