Dreame H12 Dual User Manual

15 1615 16
EN EN
1. As shown in the picture, press the
brush roller release button to remove the
roller from the slot.
2. When it is dirty, rinse thebrushroller
with clean water. Stand the brushroller
upright until it is fully dry.
1. Use a coin as illustrated to rotate the lock counterclockwise, and remove the brush
roller until you hear a click.
2. When it is dirty, rinse thebrushroller with clean water. Stand the brushroller upright
until it is fully dry.
1
2
Care and Maintenance
Cleaning the Dust Cup Assembly
Cleaning the Brush Assembly
1. Press the dust cup release button and
remove the cup.
2. Take out the lter and the cyclone
assembly from the dust cup, then empty
the cup.
Note:
•
Cleaning the dust cup after each use or after the amount of dust in the cup reaches the MAX line is
recommended.
•
Replacing the lter every 3 to 6 months is recommended.
Note: To reduce the risk
of electric shock or injury,
do not rinse the cyclone
assembly with water.
Remove the Used Water Tank, wipe the tube and the dirt
sensor with a wet cloth before use.
Cleaning the Tube and the Dirt Sensor
3. Tap the lter gently or clean it with the
cleaning brush. Rinse the lter and the
dust cup with water.
4. Dry the lter and the dust cup
completely before use.
1. First, press the brush roller cover
release buttonsinwardson both sides to
remove the brush roller cover.Next, press
the brush roller release buttonandthe
handle of the brush roller will pop out.
Pull the handle to take out the brush
roller.
2. Clean out any hair and debris tangled
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
Note:
•
Clean as needed.Alternatinguse of the two provided brush rollers is recommended.
•
Replacing the brush roller every 3 to 6 months is recommended.
CareandMaintenance
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
4. After cleaning the brush roller, re-install
the brush roller and the brush roller cover.
You will hear a click to indicate that they
are installed in place.
Cleaning the Soft Roller Brush
Cleaning the Motorized Mini-Brush

Dreame H12 Dual Specifications

General

Battery Capacity	4000 mAh
Water Tank Capacity	900 ml
Dirty Water Tank Capacity	700ml
Display	LED Display
Self-cleaning	Yes
Type	Cordless Wet and Dry Vacuum Cleaner
Charging Time	4 hours
Accessories	Charging Base, Cleaning Brush
Run Time	35 minutes