Dreame H12 Dual User Manual

7 87 8
EN EN
Insert the end of the handle vertically into the port on the top of the appliance as
indicated until you hear a click.
Note: To disassemble, extend a hard object into the hole on the back of the appliance to press contacts
and pull the handle upwards at the same time.
Installing the Accessory
Storage Mount
Installing the
Storage Box
Insert the support rod vertically into the
storage mount until you hear a click.
Install the storage box onto the charging
base.
2
咔哒
1
咔哒
Note: To remove the support rod, extend a tool into the hole on the bottom of the mount to press contacts and pull the
rod upwards at the same time.
Installing the Handle
Installation Charging
1. Place the charging baseagainst a wallon level ground and connect it to a
powersource. Fully charge the appliance before rst use.
2. Place the appliance on the charging base, the on the screenwilllight up to indicate
the charging status.When charging, the number on the display screen represents the
current battery levelasa percentage. When the numberreaches100, the battery is
fully charged and the
will turn o.
Note:
•
If no operation is performed within 10 minutes, the appliance will enter the sleep mode.
•
To extend the battery life time, the battery keeps cooling down for about one hour automatically after you
have used the appliance for a long time.
Click
Click

Dreame H12 Dual Specifications

General

Battery Capacity	4000 mAh
Water Tank Capacity	900 ml
Dirty Water Tank Capacity	700ml
Display	LED Display
Self-cleaning	Yes
Type	Cordless Wet and Dry Vacuum Cleaner
Charging Time	4 hours
Accessories	Charging Base, Cleaning Brush
Run Time	35 minutes