Dreame H12 Dual - Display Screen and Modes

Air-Drying Outlet
Power Cord
Air-Drying Inlet
Charging Contacts
1
2
3
4
4
1
2
3
5 65 6
EN EN
14
13
Wet and Dry Vacuum Floor Washer
1
2
6
3
7
4
5
8
9
10
11
12
15
16
17
18
Product Overview Product Overview
Handvac Mode Switch
Handvac Power Switch
Used Water Tank
Brush Roller Cover
Brush Roller Cover
Release Buttons
Self-Cleaning Button
Power Switch
Handvac Release Button
Used Water Tank
Handle
Display Screen
Used Water Tank
Release Button
Clean Water Tank
Brush Roller Handle
Brush Roller Release
Button
Clean Water Tank Handle
Clean Water Tank Release
Button
Mode Switch
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Voice Prompt Button
•
Press briey to activate the voice
prompt or adjust the volume
•
Press and hold for 3 seconds to
access the language settings.Press
to switch between languages. Press
andhold to conrm the selection
Charging Base
Note: If the appliance is not working properly, the screen display will show an error message. Please refer to the
troubleshooting table to nd your solution.
Error Messages
Insucient water
intheClean Water Tank
Used Water Tank full/
Used Water Tank not installed
Blocked tube
Brush roller stuck
Display Screen
Standard Mode (Handvac)
Suction Mode
Low Battery Indicator
Charging Indicator
Drying Mode
Auto Mode
Turbo Mode (Handvac)
•
Press briey to enable this
function (battery level ≥ 15%)
•
Press and hold self-cleaning
button for 3 seconds to
activate drying mode.
•
Orange: Battery level <20%
•
Green: Battery level ≥ 20%
•
Orange (charging): Battery level <20%
•
Green (charging): Battery level ≥ 20%
Self-Cleaning