Dreame H12 Dual - Self-cleaning and Handheld Use

11 1211 12
EN EN
1
2
咔哒
How to Use
Self-cleaning Mode
Drying Mode
1. Place the appliance back onto the base while you nish cleaning.
2. Briey press the self-cleaning button on the top of the handle tostart/stop self-
cleaning.
3. Empty the Used Water Tank while self-cleaning is completed. Then the appliance
starts drying mode. Press the button
to exit drying mode.
1. Press and hold the self-cleaning button for 3 seconds to activate drying mode.
2. The appliance will be charged once drying is completed.
咔哒
咔哒
Click
Click
Click
1. Press the handvac release button to remove the handvac.
2. Install the dust cup assembly and other attachments as shown in the diagram until
you hear a click.
3. Brieypressthe handvac power switch to start operating.Brieypressthe handvac
mode switch
to switch between Standard mode and Turbo mode according to your
needs.
How to Use
Using asaHandheld Vacuum
Note: The self-cleaning mode can be enabled only when the appliance is being charged and the battery level is
more than 15%.
Note: Motorized mini-brush should not be used with
the extension rod.
Note:
•
Clean the charging base if there are any stains left on the base after self-cleaning is complete.
•
If cleaning the brush roller manually, please air dry thoroughly or dry it by using drying mode several times.
自清洁水位线
Minimum Water Level
of Self-Cleaning