Dreame T20 - Page 9

14 15
Care & Maintenance
3. Remove the pre-󽗉lter 󽗉rst, then lift the handle of the cyclone assembly and turn to
counterclockwise until it stops, then pull to lift out the cyclone assembly.
Note:
• It is recommended to clean the dust compartment once every month.
• It is recommended to clean the pre-󽗉lter at least once every 3 months and the cyclone
system at least once every 6 months.
1
2
3
Pre-󽗉lter Dust Compartment Cyclone Assembly
4. Rinse the cyclone assembly, pre-󽗉lter and dust compartment until they are clean. After
washing, air dry at least 24 hours .
Installing the Dust Compartment, Pre-󽗉lter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust compartment, and make sure
that the handle of the cyclone assembly line up with the slot on the left side of the dust
compartment. Turn the handle clockwise until it locks, then 󽗊ip the handle down.
2. Place the pre-󽗉lter with its front side facing up into the cyclone assembly.
3. Slightly tilt the dust compartment so its slot aligns with the clip on the vacuum cleaner.
Then gently push the dust compartment until it clicks into place.
3
1
2
3
Care & Maintenance
12
6
111
57
210
48
39
24 hrs