Dreame T30 Neo - How to Use; Setting Language; Working Methods

14 15
ENEN
Care & Maintenance
3. Remove the pre-󽗉lter 󽗉rst, then lift the handle of the cyclone assembly and turn it counterclockwise
until it stops, then pull to lift out the cyclone assembly.
Note: It is recommended to clean the pre-󽗉lter at least once every 3 months and the cyclone system at
least once every 6 months.
1
2
3
Pre-󽗉lterCyclone Assembly
4. Wipe the dust cup with a soft wet cloth. Pay attention to wring out the discloth before using.
5. Rinse the cyclone assembly and pre-󽗉lter until they are clean. After washing, air dry for at least 24
hours .
12
6
111
57
210
48
39
24 hrs
To avoid the risk of
electric shock, do not
rinse the dust cup with
water.
Installing the Dust Cup, Pre-󽗉lter, and Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust cup, and make sure that the handle of the cyclone
assembly line up with the slot on the left side of the dust cup. Turn the handle clockwise until it locks,
then 󽗊ip the handle down.
2. Place the pre-󽗉lter with its front side facing up into the cyclone assembly.
3. Slightly tilt the dust cup so its slot aligns with the clip on the vacuum. Then gently push the dust cup
until it clicks into place.
3
1
2
3
Care & Maintenance