59
MATERIALS
Observe all provided
warnings and safety
instructions prior to and when using the
Dremel LC40 Laser Cutter. Failure to do
so may result in fire, equipment damage,
property damage and/or personal injury,
up to and including death
.
Never engrave or cut any
unknown material. Only
engrave materials recommended by the
manufacturer. The vaporization/melting of
many materials, including but not limited
to PVC and polycarbonates, can give off
hazardous fumes. Always refer to the Safety
Data Sheet (SDS) from the material
manufacturer to determine the response of
any work material to extreme heat
(burning/fire hazard) to prevent hazards.
Click to select a material from the list of
Dremel provided commonly used materials,
or choose “more” to add/delete/edit the list
of favorite materials. Use the star to denote
a default material that will be saved and
used for all jobs, until changed. The settings
that are populated when a material is
selected will be applied to all files brought
in, unless edited in the print settings box, or
changed in the materials list.
TIME
Click to calculate a rough estimate of how
long the job will take to complete.
OPTIONS
Displays more advanced settings and
defaults.
DREMEL LC40 CONTROL SOFTWARE