07-01480F F292-A 2 Dri-Eaz Products, Inc.
dehumidifiers, and are able to continue removing
moisture in colder and/or drier environments.
POSITIONING A DEHUMIDIFIER
For best results, operate your dehumidifiers in an
enclosed area, as this creates a drying chamber. Close
all doors and windows that open to the outside to
maximize the unit’s water removal efficiency. Also, keep
traffic though the drying chamber to a minimum. Place
your Evolution dehumidifier against a wall, away from
obstructions, and keep it away from anything that could
block airflow into and out of the unit.
IMPORTANT: Before moving the unit, make sure there’s
no water in the pump. See how to use the PURGE
function under “How to Use the Control Panel” on
page 3.
Managing temperature rise
Controlling temperature in the drying environment is
critical. The most accurate way to monitor temperature is
with a thermo-hygrometer; however, you can use an
indoor/outdoor thermometer to gauge temperature. For
improved accuracy, take temperature readings in the
center of the room, away from the airflow of the
dehumidifier.
Dri-Eaz dehumidifiers warm the air as they remove
moisture. Optimal drying temperatures range from 68°F–
85°F (20°C–29°C). This may require the use of the
building’s HVAC (heating or air conditioning) system. If
heating and cooling is not available at the site, call Dri-
Eaz at 800-932-3030, and a Technical Specialist will
help you find an appropriate solution.
For more information about creating an optimum drying
environment, contact Dri-Eaz at 800-932-3030.
PARTS IDENTIFICATION
1. Rotate locking lever to
right to release handle.
2. Raise handle to upright
position and secure in
place with locking lever.
3. Reverse procedure to
secure handle for shipping
and storage.
FIG. B: SECURING HANDLE
Rotate hose
storage tab
180 degrees to
the right to
release drain
hose.
FIG. C: HOSE STORAGE
FIG. A: BACK
Handle (in stored
position).
Hose storage tabs.
Rotate upper tab to
release hose.
Location of pump
and catch basin.
To Next Page
Loading...
