4
Assembly Instructions Cont.
5. Install the casters by inserting the stem of the
caster into the leg receptacle. It is recommended
to install one locking caster and one non-locking
caster on each bed end. The locking casters
should be installed diagonally from each other.
The 15005L Low Height bed gives you the option of
installing the casters on the inboard non adjustable
legs or the outboard adjustable legs. To achieve
the full low height feature, install the casters on the
inboard non-adjustable legs.
6. Carefully lower the bed frame at onto the oor. Attach the Head
and Foot Boards by tilting the Boards toward your body and aligning
mounting pins located on the Spring Sections with the Hooks on the
Head/Foot Boards.
NOTE: The Head Board is taller than the Foot Board, however, they
are interchangeable with each other.
7. Assemble Hi/Lo Drive Shaft and adjust to the proper length so it will
t between the Head Board drive pin and Hi/Lo Motor drive pin at the
foot end.
• Lift the Head Spring and install the foot end of the Hi/Lo Drive Shaft to the Hi/Lo Motor drive pin, then
install head end of the Hi/Lo Drive Shaft to the Head Board drive pin.
• Hi/Lo Drive Shaft is spring loaded so it will t securely between these two points.
• Adjust length of Hi/Lo Drive Shaft if it is too long or too short.
StemLeg Receptacle
To Next Page
Loading...
