27/29
18. REVISIONS
The following is a list of key changes between software releases.
New menu layout and “QUICKSTART” mode to allow simple for basic
lubrication parameters.
In PULSE mode, the BOOST CYCLES parameter has been excluded as
redundant.
In PULSE mode, multi cycle possibility using a PS type system has been
enabled.
Change: Modify default value for TOT REFILL parameter to 10 hours ( instead
of 2 minutes)
New: FLOW mode feature added
Change: Alarm relay activation fix for configurations using suspend feature.
New: External pressure switch input alarm added
New: In DUAL mode, secondary solenoid control enabled.
New feature: INVE WAIT parameter added
New feature : pump control mode SYNCRONIZED added
New feature: LUBE-NO-CONTROL value added
Operating test added (for internal and distributor use only)
Change: In SUSPEND parameter added tenths of seconds
Change: SUSPEND Bug-fix.
To Next Page
Loading...
