To Next PageTo Next Page
Need help?Do you have a question about the DROPSA VIP5 and is the answer not in the manual?
General| Brand | DROPSA |
|---|---|
| Model | VIP5 |
| Category | Controller |
| Language | English |
Provides a step-by-step guide for initial setup of the VIP5 Controller.
Defines key operational phases like Lubrication Phase and Standby Phase.
Explains the operating principles for CYCLE and PULSE control systems.
Describes the pre-lubrication cycle triggered on power-on or reset.
Details the lubrication cycle, including activation, control, delay, and wait times.
Explains the system's inactive period awaiting the next lubrication phase.
Describes the VIP5's function as a flow monitoring device.
Guidelines for safely unpacking the VIP5 unit from its shipping box.
Instructions for physically securing and cabling the VIP5 controller.
Details the M1 and M2 terminal strip connections for inputs and outputs.
Provides visual examples of common wiring configurations for the VIP5.
Explains how to activate the battery for date/time and save functions.
Safety advice and precautions to follow when carrying out wiring.
Identifies front panel components, LEDs, and their operational status.
Describes operation where a cycle sensor determines lubrication phase completion.
Describes operation where Standby and Lubrication phases are determined by an external counter.
Describes operation as a flow monitoring and display device.
Details the pre-lubrication cycle triggered on power-on or reset.
Lists the four possible cycle monitoring options available.
Operation based solely on a preset timer value for lubrication cycles.
Monitoring using a pressure switch, typically for injector systems.
Monitoring for progressive systems using cycle switch feedback.
Monitoring using two pressure switches for dual line systems.
Advice on controlling directional valves in dual line lubrication systems.
Guide to navigating through the VIP5 setup menus and parameters.
Overview of the Quick setup (Basic) and comprehensive (Extended) menus.
Details on special functions like LCD contrast, flow totalizer, and time/date settings.
Lists and explains possible alarm codes and troubleshooting steps.
Procedures for handling alarms and resetting the VIP5 controller.
How to use the alarm relay for coded alarm signals to a PLC.
