3. Safety
3.1 General
Caution - Carefully read this chapter on safety,
before you start performing installation
or maintenance work;
- Please observe the general regulations and
the precautions/safety instructions in this
manual.
3.2 Regulations
• Please install the appliance, including the electrical
installation, in accordance with the applicable national,
local and constructional (installation) regulations.
These are included in, for instance:
- Gas Safety (Installation and Use) Regulations;
- B.S. 6891;
- B.S. 5871: Part 1;
- B.S. 5440: Part 1;
- B.S. 5440: Part 2;
- Local Building Regulations;
- I.E.E Wiring Regulations;
- Health and Safety at work
3.3 Precautions / safety instructions during
installation
Carefully observe the following precautions/safety
regulations:
• you should only install and maintain the appliance if you
are a competent installer in the field of gas heating:
• do not make any changes to the appliance;
• only use the flue gas discharge / combustion air supply
material supplied by Drugasar;
• always place the appliance against a wall of incombustible
and heat-resistant material;
• use the wall brackets when mounting the appliance to the
wall. This will guarantee the minimum required distance
of 10 mm from the back wall;
• make sure the appliance has sufficient distance from
other objects and materials (see fig. 1). The free space
surrounding the appliance is necessary for a proper
and safe operation and for accessibility in case of
maintenance;
• make sure there is a free outflow of warm convection air
at the front of the appliance;
• make sure there is a free supply of cold convection air at
both sides of the appliance; Curtains, for example, could
block the inlet as a result of the sucking action of the
convection fan.
• avoid warm convection air from recirculation through the
cold convection air inlet;
• do not cover the appliance and the discharge material
and/or do not wrap it in an insulation blanket or any
other material;
• avoid dirt in gas tubes and connections;
• check the connections for gastightness before using the
appliance;
• do not place and/or use the appliance in a moist
environment;
• place an all-pole switch near the appliance, with a contact
opening of at least 3 mm;
• connect the appliance to earth;
• place electrical connections in such a way that they are
free from the appliance;
• do not ignite the appliance until it is fully installed.
4. Removing the packaging
Note the following items when removing the packaging:
• Check the appliance for damages during transport.
• If necessary, contact Drugasar Service.
• Check whether all parts have been supplied.
In Appendix 1 you can see which parts you should have
after removing the packaging.
• Contact Drugasar Service if you do not have all the parts
after you finished removing the packaging.
• Dispose packaging in accordance with local regulations.
Kamara
INSTRUCTIONS FOR INSTALLATION
!
Fig. 1
3
English
To Next Page
Loading...