DSC HS2128 - 7.3 System Times

Section 7: Programming Worksheets
7.3 System Times
[005] System Times
000 – System Area
Bell Cutoff (Default: 004 minutes):
Description
on page 77
(3-Digit Decimal)
Bell Delay Time (Default: 000 minutes):
Burglary Verification Timer (Default: 060 minutes):
Holdup Verification Timer (Default: 008 hours):
Zone Loop Response Time (Default: 025 x 10ms):
Automatic Clock Adjust (Default: 060 seconds):
001 – Partition 1 Timer
Entry Delay 1 (Default: 030):
Entry Delay 2 (Default: 045
CP-01
Default: 030):
Exit Delay (Default: 120
CP-01
Default: 060):
Settle Delay (Default: 010
CP-01
Default: 000):
002 – Partition 2 Timer
Entry Delay 1:
See partition 1 for defaults
Entry Delay 2:
Exit Delay:
Settle Delay:
003 – Partition 3 Timer
Entry Delay 1:
See partition 1 for defaults
Entry Delay 2:
Exit Delay:
Settle Delay:
004 – Partition 4 Timer
Entry Delay 1:
See partition 1 for defaults
Entry Delay 2:
Exit Delay:
Settle Delay:
005 – Partition 5 Timer
Entry Delay 1:
See partition 1 for defaults
Entry Delay 2:
Exit Delay:
Settle Delay:
006 – Partition 6 Timer
Entry Delay 1:
See partition 1 for defaults
Entry Delay 2:
Exit Delay:
Settle Delay:
007 – Partition 7 Timer
Entry Delay 1:
- 146 -