DSC HS2128 - System Options

Section 7: Programming Worksheets
Keypad Lockout Duration:
(Range: 001-255; Default 000)
Note: For
EN
installations minimum programmed duration of 2 minutes.
Remote Lockout: (Range: 003-255; Default 006)
Remote Lockout Duration: (Range: 001-255; Default 060)
7.7 System Options
[013] System Options 1
Description on page 96
o 1 – NC Loop/EOL
o 2 – DEOL/SEOL
EN
R 2 – DEOL/SEOL
R 3 – Show All Troubles When Armed
o 4 – Tamper/Faults Open Zone
R 5 – Auto-Arm Schedule in [*][6]
R 6 – Audible Exit Fault
R 7 – Event Buffer Follows Swinger
o 8 – Temporal Three Fire Signaling
[014] System Options 2
Description on page 97
o 1 – Bell Squawk
o 2 – Bell Squawk on Auto-Arm
o 3 – Bell Squawk on Exit
o 4 – Bell Squawk on Entry
o 5 – Bell Squawk on Trouble
o 6 – Not Used
o 7 – Exit Delay Termination
o 8 – Fire Bell Continues
[015] System Options 3
Description on page 98
R 1 – [F] Key Enabled
o 2 – [P] Key Annunciation
o 3 – Quick Exit
R 4 – Quick Arming/Function Key
o 5 – Not Used
o 6 – Master Code Not User Changeable
R 7 – Telephone Line Monitor Enable
- 161 -