DSC HS2128 - Page 182

Section 7: Programming Worksheets
(
CP-01
Default: 002)
Maintenance and Restore:
002 – Communication Delays: Communication Zone Delay (Default: 000
CP-01
Default: 030):
AC Failure Communication Delay (Default:030 minutes/Hours):
TLM Trouble Delay (
NA
Default:010 checks
EN
Default:002
checks):
Wireless Zone Low Bat. Transmission Delay (Default: 007 days):
Delinquency Transmission Cycle Delay (Default: 030 days/hours):
Communications Cancel Window (Default: 000 minutes
CP-01
Default:
005 minutes):
003 – Periodic Test Transmission Cycle (Default: 030 hours/days):
004 – Periodic Test Transmission Time of Day (Default: 9999):
011 – Maximum Dialing Attempts: (Default: 005):
012 – Delay Between PSTN Attempts: (Default: 003 seconds):
013 – Delay Between Force Attempts: (Default: 020 seconds):
014 – Post Dial Wait for Handshake: (Range: 001-255; Default: 040 Seconds; UL=45):
015 – IP/GS Wait for Ack: (Range: 001-255; Default: 060 seconds):
016 – IP/Cellular Fault Check Timer: (Range: 003-255; Default: 010):
[380]
Communicator Option 1
1 – R Communications Enabled
2 – o Restore on Bell Time-out
Description on page page 1
3 – o Pulse Dialing
4 – o Pulse Dial after 5th Attempt
5 – o Parallel Communications
NA
6 –
o
Alternate Dial
EN
6 –
R
Alternate Dial
7 – o Reduced Dialing Attempts
8 – o Activity Delinquency
[381]
Communicator Option 2
1 – o Keypad Ringback
Description on page 1
2 – o Bell Ringback
4 – o Closing Confirmation
8 – o Communications Priority Options
[382]
Communicator Option 3
2 – o Walk Test Communication
- 182 -