DSC HS2128 - Page 204

Section 8: Troubleshooting
Trouble Detailed Trouble
07 – Device Tampers
01 – Zone 1-128
02 – Keypad 1-16
03 – Siren 1-16
04 – Repeater 1-8
05 – Audio Station 01 - 04
08 – RF Delinquency
01 – Zone 1-128
02 – Keypad 1-16
03 – Siren 1-16
04 – Repeater 1-8
09 – Module Supervisory
01 – HSM2HOSTx
02 – Keypad 1-16
04 – HSM2108 1-15
05 – HSM2300 1-4
06 – HSM2204
08 – HSM2208 1-4
09 – HSM2955
10 – Module Tamper
01 – HSM2HOSTx
02 – Keypad 1-16
04 – HSM2108 1-15
05 – HSM2300 1-4
06 – HSM2204
08 – HSM2208 1-4
09 – HSM2955
11 – Communications
01 – TLM
02 – FTC Receiver 1-4
03 – Alt. comm SIM lock
04 – Alt. comm cellular
05 – Alt. comm Ethernet
06 – Receiver 1-4 absent
07 – Receiver 1-4 supervision
09 – Alt. comm fault
10 – Alt. comm FTCtrouble
12 – Not Networked
01 – Zone 1-128
02 – Keypad 1-16
03 – Siren 1-16
04 – Repeater 1-8
05 – User 1-32
Trouble [1] Service Required Press [01] to determine specific trouble
Trouble Troubleshooting
[01] Bell Circuit
Bell+, Bell-...open circuit.
Disconnect Bell-/+ leads and measure resistance:
Open circuit indicates break in wiring or defective siren/bell.
Jumper Bell+/- with 1K resistor (Brown, Black, Red):
[02] RF Jam Detected
Wireless receiver - excessive noise detected.
Check event buffer to determine specific trouble.
If buffer logs RF jam, check for RF interference.
Disable RF Jam: section [804] sub-section [801].
- 204 -