Troubles
Troubles
When a trouble condition is detected, the Trouble ( ) or System indicator will turn on, and the keypad
will beep every 10 seconds. Press the ( ) key to silence the beeps. Press ( ) to view the trouble con-
dition. The Trouble ( ) or System indicator will flash. The corresponding trouble will light up.
Troubles Comments Action
Service
Required (Press
for more
details)
Low Battery General System Supervision
Bell Circuit RF Jam Detected
General System Trouble Panel Low Battery
General System Tamper Panel AC Loss
Call for
service
AC Loss
If the building and/or neighborhood has lost electrical power, the system
will continue to operate on battery for several hours.
Call for
service
Phone Trouble The system has detected that the telephone line is disconnected.
Call for
service
Communication
Failure
The system attempted to communicate with the monitoring station, but
failed. This may be due to Telephone Line Fault.
Call for
service
Zone Fault
The system is experiencing difficulties with one or more sensors on the
system. Press to display the zone.
Call for
service
Zone Tamper
The system has detected a tamper condition with one or more sensors on
the system. Press to display the zone.
Call for
service
Wireless Low
Battery
The system has detected a low battery condition with one or more mod-
ules/sensors on the system. Press to display the zone, keypad, wireless key
(s) and RF Delinquency low battery conditions. Press again to see zone
troubles.
Call for
service
Loss of Clock
If complete power was lost (AC and Battery), the time and date will need
to be reprogrammed.
Reprogram
Time &
Date
Alarm Memory
When an alarm occurs, the Alarm indicator flashes.
To view which sensor(s) generated the alarm, press Alarms.
The sensor number where the alarm occurred will be displayed (e.g., zone 3). Use the [<][>] scroll keys to
view the sensors in alarm memory. Press Back or Home to exit. To clear the memory, arm and disarm the sys-
tem. If an alarm sounded while armed, the keypad will automatically go to alarm memory when you disarm
the system. In this instance, you should approach with caution, as the intruder may still be within the build-
ing/premises.
- 15 -
To Next Page
Loading...
Need help?
General
