ALARM TEST
Press
I*]
lhen
[4]
for a 4 second lest of the keypad lights, keypad sounder and
sirens. This is a local lest only. A lest transmission to the monitoring station is
not done with this command.
PROGRAMMING ADDITIONAL SECURITY CODES
Enter
[*I&]
and [master security code]. The ‘PROGRAM’ light will flash and
the ‘ZONE’ lights will show which codes have already been programmed (up to
8 codes can be programmed from the keypad).
Press any key from (1 to
81
to indicate which one of the 8 codes is being
programmed. The ‘ZONE’ light will flash to indicate which code is being
programmed.
Enter a
[4
digit security code]. At this point if
[
*
JC
*
xc]
instead of a
[4
digit code] is
entered, any previously programmed code in this localion will be eliminated.
To review:
programming a new code;
enter
[*]$$[master
code],(l to
8],[4
digit code].
eliminating an existing code;
enter
[*],[5].[master
code].[l to
S],[xx-x-x]
Press
[#]
to return to ‘READY’.
SETTING AUTOMATIC ARMING TIME
The PC2000 can be programmed to automatically arm each day at the same
lime. To set the lime, enter
(~1,
(61
and a (4 digit security code]. Then enter any
[two digits] (from 01 to 23) for the number of hours until arming is to take place.
For example if it is 3:00 pm and auto-arming is to take place at 8:00 pm enter
05 for the five hours between 3:00 pm and 8:00 pm.
,..
*
_
-”
Press
[#]
to return to ‘READY’.
.
.
.
The
[-K]
[S]
command is only used to set the arming time. The
[x]
[8]
command
is used to turn on and off the auto-arm feature. See “PROGRAMMING
OTHER FEATURES”.
To Next Page
Loading...
Need help?
General
