EasyManua.ls Logo

DSC PC585 - Page 36

DSC PC585
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
P R O G R A M M I N G W O R K S H E E T S
PGM Output Attributes
(Section 5.11 “PGM Output Options”)
Program only the following attributes for the PGM Options listed. All others will be ignored. PGM Options are programmed in
section [009].
PGM Attribute Defaults (Y = Attribute ON; N = Attribute OFF):
Attribute: 1 2 3 4 5
ON Output enabled True Output Follows Timer Code Req.
OFF Output disabled Inverted On / Off No Code Req.
PGM Option
[01] Burg. / Fire Bell Y Y
[03] Sensor Reset Y Y N
[05] Armed Status Y Y
[06] Ready To Arm Y Y
[07] Kypd Bzz Follow Y Y
[08] Courtesy Pulse Y Y
[11] System Tamper Y
[12] TLM and Alarm Y
[13] Kiss-off Y
[14] Gnd Strt Pulse Y
[15] Remote Op. Y
[16] LINKS1000 Sup. Y
[17] Away Armed Status Y Y
[18] Stay Armed Status Y Y
[19] Comm. Output #1 Y Y Y Y
[20] Comm. Output #2 Y Y Y N
Attribute: 1 2 3 45678
PGM Option
ON Serv. req. AC Fail TLM Fault FTC Zone Fault Zone Tmp. Zn. Low Bat. Loss of Clock
OFF Disabled Disabled Disabled Disabled Disabled Disabled Disabled Disabled
[09] System Trouble Y YYYYYYY
ON Burg. Evnt. Fire Evnt. Panic Evnt. Med. Evnt. Supv. Evnt. Priority Evnt. Holdup Evnt. Follows Timer*
OFF Disabled Disabled Disabled Disabled Disabled Disabled Disabled Latched
[10] System Event Y Y N Y N N N N
*If attribute [8] is turned ON, attributes [1-7] must also be turned ON.
Section PGM Output 1 2 3 45678
# Type*
[141] 1
( ) I________I I________| I________| I________| I________| I________| I________| I________I
[142] 2 ( ) I________I I________| I________| I________| I________| I________| I________| I________I
*Record here based on programming in section [009]
[160] Maximum Dialing Attempts to Each Telephone Number
(Section 5.5 “Communicator Dialing”)
Default: 008 I_______I_______I_______I Valid entries are 001-255 attempts (Do not enter 000)
[161] Post Dial Wait for Handshake (All Formats)
(Section 5.5 “Communicator Dialing”)
Default: 040 I_______I_______I_______I Valid entries are 001-255 seconds
[164] PGM Output Timer
(Section 5.11 “PGM Output Options”)
Default: 005 I_______I_______I_______I Valid entries are 001-255 seconds

Table of Contents

Related product manuals