DSC PC585 - Page 41

37
P R O G R A M M I N G W O R K S H E E T S
[367] System Maintenance Alarm/Restore Communicator Call Directions
(Section 5.5 “Communicator – Dialing”)
Default Option ON OFF
ON I________I 1 1st Telephone Number Disabled
OFF
I________I 2 2nd Telephone Number Disabled
OFF I________I 3 1st Telephone Number (via LINKS) Disabled
OFF I________I 4 2nd Telephone Number (via LINKS) Disabled
OFF
I________I 5-8 For Future Use
[368] System Test Transmissions Communicator Call Directions
(Section 5.5 “Communicator – Dialing”)
Default Option ON OFF
ON
I________I 1 1st Telephone Number Disabled
OFF I________I 2 2nd Telephone Number Disabled
OFF I________I 3 1st Telephone Number (via LINKS) Disabled
OFF
I________I 4 2nd Telephone Number (via LINKS) Disabled
OFF I________I 5-8 For Future Use
The LINKS1000 backup call directions will only back up their respective telephone numbers.
[370] Communication Variables
Default Section
003
I_______I_______I_______I Swinger Shutdown (Alarms and Rest) (001-014 Transmissions, 000=disabled) 5.19
003 I_______I_______I_______I Swinger Shutdown (Tampers and Rest) (001-014 Transmissions, 000=disabled) 5.19
003
I_______I_______I_______I Swinger Shutdown (Maint and Rest) (001-014 Transmissions, 000=disabled) 5.19
000 I_______I_______I_______I Transmission Delay (001-255 seconds) 5.15
030 I_______I_______I_______I AC Failure Communication Delay (001-255 minutes) 5.8
003
I_______I_______I_______I TLM Trouble Delay (No. of checks required - valid entries 003 - 255) 5.12
030 I_______I_______I_______I Test Transmission Cycle (land line) (001-255 minutes/days)† 5.14
030 I_______I_______I_______I Test Transmission Cycle (LINKS) (001-255 days) 5.14
007
I_______I_______I_______I Zone Low Battery Transmission Delay (000-255 days) 5.8
030 I_______I_______I_______I Delinquency Transmission Cycle (001-255 days / hours)* 5.8
†Depends on programming in section [702], option [3].
*Depends on programming in section [380], option [8].
NOTE: To disable the AC failure communications delay, program [000].
[371] Test Transmission Time of Day
(Section 5.14 “Test Transmission”)
NOTE: If the land line test transmission cycle is programmed in minutes (section [702], option [3]), this section will not
affect the land line test transmission cycle.
Default
9999 I_______I_______I_______I_______I (Valid entries are 0000-2359, 9999 to disable)
[380] First Communicator Option Code
Default Option ON OFF Section
ON
I_______I 1 Communications Enabled Communications Disabled 5.5
OFF I_______I 2 Restorals on Bell Time-out Restorals Follow Zones 5.8
OFF I_______I 3 Pulse Dialing DTMF Dialing 5.5
ON
I_______I 4 Switch to Pulse Dialing on 5th Attempt DTMF Dial For All Attempts 5.5
OFF I_______I 5 3rd Telephone Number enabled 3rd Telephone Number disabled 5.7
OFF I_______I 6 Alternate Dial (1st and 3rd) Call 1st Number, Backup to 3rd 5.7
OFF
I_______I 7 Call LINKS as well as Land Line LINKS is Backup of Land Line(s) 5.26
OFF I_______I 8 Delinquency Follows Zone Activity (hours)Delinquency Follows Arming (days) 5.8