Why does my DSC PowerSeries PC1616 show PC5204 Low Battery?
If your DSC Control Panel is showing a PC5204 Low Battery warning, it means the PC5204 battery voltage is less than 11.5VDC. Note that this trouble condition will not clear until the battery voltage reaches 12.5VDC minimum, under load. Please refer to the 'Low Battery' troubleshooting steps.
What causes a PC5204 AC Failure on DSC PowerSeries PC1616 Control Panel and how to resolve it?
A PC5204 AC Failure on your DSC Control Panel indicates that there is no AC power at the PC5204 AC inputs. Verify the voltage measured across the AC terminals is 16-18VAC. Replace the transformer if required.
What to do if my DSC PowerSeries PC1616 Control Panel has a low battery?
If your DSC Control Panel displays a low battery warning, it could be due to the main panel battery voltage being less than 11.1VDC. Note that the trouble condition will not clear until the battery voltage is at least 12.5VDC under load. If the battery is new, allow one hour for it to charge. Verify the voltage measured across the AC terminals is 16-18 VAC, and replace the transformer if needed. Disconnect the battery wire leads and verify the battery charging voltage measured across the battery leads is 13.70 - 13.80 VDC. Connect the battery and remove AC power, then verify the measured voltage across the battery terminals is 12.5VDC minimum.
How to fix AC Failure on DSC PowerSeries PC1616 Control Panel?
If you are experiencing an AC failure with your DSC Control Panel, verify that the voltage measured across the AC terminals is between 16-18VAC. If it is not, you may need to replace the transformer.
Explanation of symbols on LCD5501 fixed message and icon keypads.
Explanation of symbols and indicators on the LCD5511 keypad.
Explanation of symbols on PK5501/PK5508/PK5516 keypads.
Guidance on performing weekly system tests and upkeep.
Instructions for arming and disarming the security system.
Instructions for disarming the system and handling errors.
How to arm in Stay mode and re-activate bypassed zones.
How to use the Fire, Auxiliary, and Panic emergency keys.
How to respond to Intrusion and Fire alarms.
How to bypass zones to temporarily exclude them from protection.
How to bypass zones on LCD5500Z and PC55XXZ/LCD5501Z keypads.
Identifying, viewing, and acknowledging system troubles.
How to program and manage user access codes.
Details on User, Master, Supervisor, and Duress codes.
Performing comprehensive system tests for all components.
Performing a walk test to verify detector operation.
How to reset specific sensors after an alarm condition.
Testing the keypad sounder and siren functionality.
Comprehensive steps to test the entire alarm system weekly.
General| Partitions | 2 |
|---|---|
| Keypads | Up to 8 |
| Zones | 6 on-board |
| PGMs | 2 |
| Power Supply | 16.5VAC |
| Battery Backup | 12VDC, 4Ah |
To Next Page
