5
Disarming Error
If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this hap-
pens, press [#] and try again.
Stay Arming (Partially Turning On / Part Setting)
Ask your alarm company if this function is available on your system.
Stay arming will bypass the interior protection (i.e. motion sensors) and arm the perimeter of the sys-
tem (i.e. doors and windows). Close all sensors (i.e. stop motion and close doors). The Ready ( )
indicator should be on. Press and hold the Stay key ( ) for 2 seconds and/or enter your Access
Code and do not leave the premises (if your installer has programmed this button). During the set-
ting state (exit delay active), the Armed ( ) and Ready ( ) indicators will turn on.
When the exit delay is completed, the alarm system is armed/set and this is indicated on the keypad
as follows: the Ready (
) indicator will turn off, the Armed ( ) indicator will remain on and the key-
pad will stop sounding. The Armed ( ) indicator and Bypass or System indicator will turn on. The
system will automatically bypass certain interior sensors (i.e. motion sensors).
NOTE: For SIA FAR listed panels, the Stay Arming Exit Delay will be twice as long as the Away
Arming Exit Delay.
Night Arming
To fully arm the system when it has been armed in Stay Mode, press [][1] at any keypad. All interior
zones will now be armed except for devices programmed as Night Zones. Night zones are only armed
in Away mode, this permits limited movement within the premises when the system is fully armed.
Ensure that your installer has provided you with a list identifying zones programmed as night zones.
When the interior zones have been activated (i.e., ( )(1) you must enter your access code to disarm
the system to gain access to interior areas that have not been programmed as night zones.
No-Entry Arming
This allows the system to be armed without an Entry Delay from zones that normally have one.
An entry through any zone will then create an instant alarm.
1. Check that your system is ready to be armed (Ready light is ON)
2. Press [][9], then your [access code].
• The Armed light flashes as a reminder that the system is armed and has no entry delay.
• The keypad sounds fast beeps.
• The keypad displays “Exit Delay in Progress”.
3. The system is now armed in Stay mode.
Silent Exit Delay
If the system is armed using the Stay key ( ) (Programmable Function Key) or using the "No
Entry" Arming method ([][9][access code]), the audible progress annunciation (keypad buzzer) will
be silenced, and the exit time will be doubled for that exit period only (CP-01 versions only).
NOTE: For non CP-01 versions, Standard Exit Time is used.
Remote Arming and Disarming
The system can be armed and/or disarmed using the remote control device (wireless key). When arming
the system by using the Arm button on the wireless key, the system will acknowledge the command by
sounding a single bell squawk (if bell squawk is enabled) and when disarming using the Disarm button
on the wireless key the system will acknowledge the command by sounding two bell squawks (if bell
squawk is enabled) that can be heard from the exterior of the premises.
Emergency Keys
Press the (F), (A)or (P) key for 2 seconds to generate a Fire, Auxiliary or Panic alarm. The key-
pad sounder will beep indicating that the alarm input has been accepted and transmission to the cen-
tral station is underway. Ask your alarm company if the emergency keys are available on your system.
NOTE: The Fire keys can be disabled by the installer.
LED5511/LCD5511 Keypad
Press and hold both keys simultaneously for 2 seconds to send the following messages:
Fire Message, Auxiliary Message, Panic Message.
To Next Page
Loading...
Need help?
General
