12
5.2 Test Wireless Key Reception
The wireless key cannot be tested using the module placement test described above. To
ensure that the RF5108-433 is receiving transmissions from these devices, conduct the
following tests:
WS4939/WLS919: Use the function keys to arm and disarm the system at several
different points in the installation.
If these devices do not operate from all points in the installation, you will need to move
the RF5108-433 receiver. Moving the RF5108-433 higher will usually improve the
reception.
If you move the RF5108-433, repeat the tests described in sections 5.1 and 5.2 on
all the wireless devices. Continue to test the devices until you have found satisfactory
locations for the RF5108-433 and the devices, and there is good reception between
the RF5108-433 and the Wireless Keys.
Mount the RF5108-433 and Wireless Devices
When you have tested reception of the RF5108-433 with all the wireless devices (see
section 5.1) and you have a good mounting location, mount the RF5108-433:
1. Pull the Keybus wires through the hole at the bottom of the cabinet.
2. Mount the cabinet securely to the wall.
Mount the Devices
If you have conducted the placement test described in section 5.1 and got three “Good”
results in a row for each device, you can mount the wireless devices. See the
Installation
Sheet
for each device for mounting instructions.
Now that your RF5108-433 and wireless devices are mounted and working properly, read
section 6 for information on potential wireless trouble conditions, RF jamming signals, and
battery replacement.
T E S T I N G & M O U N T I N G
To Next Page
Loading...
