DSC TL280 - Ethernet Cellular Programming Worksheets

Ethernet Cellular Programming
Worksheets
System Options
[001] Ethernet IP Address
Default (000.000.000.000)
[002] Ethernet IP Subnet Mask
Default (255.255.255.000)
[003] Ethernet Gateway IP Address
Default (000.000.000.000)
[004] Receiver Supervision Interval
Default (0087/135) Valid range: 0000 - FFFF.
[005] System Toggle Options
[1] Ethernet Receiver 1 Supervised Default (OFF).
[2] Reserved.
[3] Supervision Type Default (OFF).
[4] Reserved.
[5] Reserved.
[6] Remote Firmware Upgrade Default (ON).
[7] Alternate Test Transmission Default (OFF).
[8] Reserved.
[006] System Toggle Options 2
[1] Ethernet Receiver 1 Enabled Default (ON).
[2] Ethernet Receiver 2 Enabled Default (ON).
[8] Network Trouble Suppression Default (OFF).
[007] DNS Server IP 1
Default (000.000.000.000)
[008] DNS Server IP 2
Default (000.000.000.000)
Programming Options
[010] System Toggle Options 3
[1] Reserved
[2] Visual Verification Default (OFF).
[3] Reserved
[011] Installer Code
Default (CAFE) Valid range: 0000 - FFFF.
[012] DLS Incoming Port
Default (0BF6/3062) Valid range: 0000 - FFFF.
[013] DLS Outgoing Port
Default (0BFA/3066) Valid range: 0000 - FFFF.
[015] DLS Call-Up IP
Default (000.000.000.000)
[016] DLS Call-Up Port
Default (0000) Valid range: 0000 - FFFF.
[020] Time Zone
Default (00) Valid range: 00 - 99.
[021] Account Code
Default (FFFFFF) Valid range: 000001 - FFFFFE.
[022] Communications Format
Default (04) Program 03 (CID), 04 (SIA).
[023] Panel Absent Trouble
Default (FF); Program 00 disable or FF enable.
[024] Panel Absent Trouble Restore
Default (FF) Program 00 disable or FF enable.
System Test Options
[026] Ethernet 1 Transmission
Default (FF) Program 00 disable or FF enable.
[027] Ethernet 2 Transmission
Default (00) Program 00 disable or FF enable.
[030] FTC Restore
Default (FF) Program 00 disable or FF enable.
[037] Panel Firmware Update Fail
Default (FF) Program 00 disable or FF enable.
[095] SA Incoming Local Port
Default (0000) Valid range: 0000 - FFFF.
[096] SA Outgoing Local Port
Default (0000) Valid range: 0000 - FFFF.
22