dSPACE CLP1104 User Manual

■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Troubleshooting
DS1104 Hardware Installation and Configuration March 2004
167
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
The following table displays the affected dSPACE boards and the
property pages showing the boards’ serial numbers:
For details, see Platform Properties in the ControlDesk Reference.
N
■ After using the Clear System command, you must reregister all
installed dSPACE boards that do not support plug & play or where
plug & play mode is disabled by means of the address switches.
■ It is your responsibility to check and ensure that all applications are
still loaded to the correct board. Since this is not under complete
control of the dSPACE software it might even be necessary to
change external connections to the boards! In a subsequent
release of the Platform Manager it will be possible to assign board
names to the particular boards as needed.
dSPACE Board Property Page
DS1005 DS1005 Properties page
DS1103 DS1103 Properties page
DS1104 Board Properties page
DS1401
(MicroAutoBox)
DS1401 Properties page

dSPACE CLP1104 Specifications

General

Brand	dSPACE
Model	CLP1104
Category	Controller
Language	English