dSPACE CLP1104 User Manual

Signal Connection to External Devices ▲ ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■
DS1104 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■ ▼
146
■■■■■■■■■■■■■■■▼
General Notes and Tips on
Signal Conditioning
In addition to this section (= general notes) you will find specific notes
and tips on signal conditioning according to the I/O units of the board.
You should also refer to these.
Noise, crosstalk and inductive effects can degrade the signal and lead
to incorrect results if the following are not performed correctly:
■ Grounding and Shielding on page 147
■ Avoiding Crosstalk on page 151
■ Wiring Up External Devices on page 152
ADC performance of
dSPACE boards
When you are sampling an unconnected A/D input, you are looking at
a noisy signal traced in ControlDesk. This may give the impression that
the performance of the A/D sections of dSPACE boards is poor.
For an explanation of this incorrect impression and further background
information (definition of SNR, measuring noise), refer to ADC
Performance of dSPACE Boards on page 153.

dSPACE CLP1104 Specifications

General

Brand	dSPACE
Model	CLP1104
Category	Controller
Language	English