Implementing and Handling Applications
▲
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
DS1104 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■
▼
58
■■■■■■■■■■■■■■■▼
How to Use Scoutcmd to Load and Start
Applications
To download and start applications on the real-time hardware, you can
use the Platform Manager as a batch client using the scoutcmd
command and additional parameters.
To load an application to the global memory using scoutcmd
➤ In a DOS window, enter
scoutcmd -b ds1104 test.sdf
The
test.sdf application
is loaded to the board, and the RTP is
started.
To load an application to the flash memory using scoutcmd
➤ In a DOS window, enter
scoutcmd -b ds1104 test.sdf -fl
The
test.sdf
application is loaded to the flash memory
(parameter -fl), and the RTP is started.
T
If the parameter -b is not used with the scoutcmd command, the
application is downloaded to and started on the current working
board.
For further information on scoutcmd and its parameters, refer to
Handling Applications Using Command Line Parameters in the
ControlDesk Experiment Guide.
To Next Page
Loading...
Need help?
General
